USG Compässo Elite Suspension Trim System - Manual

1 3 / 4 " (height) tee
C OMPÄSSO E LITE
attachment clip
C OMPÄSSO E LITE trim
Compässo
™
Elite
Suspension Trim System
Before beginning installation of the C OMPÄSSO ™ Elite Ceiling System, check the enclosed bill of materials to
ensure that all parts are present and undamaged. Read all installation instructions first and familiarize yourself
with the system’s components. This is extremely important because parts will become permanently damaged if
they are installed incorrectly! To help with identification, all parts are poly-bagged. This is to be used with the
IC464 General Installation Guide.
Tip Sheet
Parts and Components
May include some or all of the following:
65.80
65.80
79.97
43.24
77.72
72.43
69.50 corner splice plate (bend 90)
R81
R54
R63 R135
R47
R42
R49
field cut
field cut field cut field cut
field cut
finish face
finish face
finish face
37.15
37.15
142
1 2
3
4
6 7
8
9
10
11
11
11
5
11
Bill of Materials (BOM) and
Reflected Ceiling Plan Suspension Trim—Straight
(available in 2", 4", 6", 8" and 10" heights) Suspension Trim – Curved
(available in 2", 4", 6", 8" and 10" heights)
Splice Plate Attachment Clips 90° Inside Corner
90° Outside Corner (12" x 12")
Outside corners are delivered with the
system as one piece, mitered and formed.
C OMPÄSSO Elite Clip Installation 1. Install clip into lower boss (tracks of C OMPÄSSO Elite)
and tighten screw.
2. Align cut grid member on side of clip and fasten
with self-tapping screw.
Note: If grid clip occurs at a splice, remove the tab portion of the clip and use the same screw to attach to one of the two tapped holes in
the center of the splice. Slide splice left or right to suit.
C OMPÄSSO Elite Trim
C OMPÄSSO Elite
Attachment Clip
1-3/4" (height) tee