Compositions, Decorative clouds installation – USG Compositions Decorative Clouds User Manual

Page 8

Install the remaining end caps and check the system for squareness. At this point the attachment clips may

be locked into place. The attachment clips are locked by inserting a flat-blade or straight screwdriver into

the vertical slot in the clip and twisting clockwise keying the clip into the trim. Be sure all hanger wires are

securely wrapped.

Install ceiling panels after checking for system squareness.

Safety First!
Follow good safety/industrial hygiene
practices during installation. Wear
appropriate personal protective
equipment. Read MSDS and literature
before specification and installation.

please consult with a licensed architect
or engineer in the particular locale of
the installation to assure compliance
with all legal requirements.
ICC Evaluation Service, Inc.,

Report Compliance
Suspension systems manufactured
by USG Interiors, LLC, have been
reviewed and are approved by listing
in ICC-Evaluation Service Report
ESR-1222. Evaluation Reports are
subject to reexamination, revision and
possible cancellation. Please refer to
usgdesignstudio.com or usg.com for
current reports.

L.A. Research Report Compliance
D

onn

brand suspension systems

manufactured by USG Interiors, LLC,
have been reviewed and are approved
by listing in the following L.A. Research
Report number: 25764.
Notice
We shall not be liable for incidental
and consequential damages, directly
or indirectly sustained, nor for any loss
caused by application of these goods
not in accordance with current printed
instructions or for other than the intended
use. Our liability is expressly limited to
replacement of defective goods. Any claim
shall be deemed waived unless made in
writing to us within thirty (30) days from
date it was or reasonably should have
been discovered.

Product Information
See usg.com for the most up-to-date
product information.
Installation
Must be installed in compliance with
ASTM C636, ASTM E580, CISCA and
standard industry practices, within
all applicable code requirements.
Alternative assemblies and installation
methods may be utilized when approved
by the Authority Having Jurisdiction.
USG recommends checking with the
Authority Having Jurisdiction prior to
designing and installing a suspended
ceiling system.

Code compliance
The information presented is correct to
the best of our knowledge at the date
of issuance. Because codes continue to
evolve, check with a local official prior to
designing and installing a ceiling system.
Other restrictions and exemptions may
apply. This is only intended as a quick
installation reference.
Restraint / Seismic Bracing
If restraint or seismic bracing is
required please refer to Seismic
Technical Guide - Specialty Decorative
Ceilings, SC2494, for more information
and examples of seismically tested
bracing methods. Prior to installation

Physical Data/

Footnotes

usg.com
seismicceilings.com
sustainableceilings.com
usgdesignstudio.com

The following are trademarks of USG interiors, LLC
or a related company: C

ompässo

, C

ompositions

, DX, DXL, D

onn

UsG, UsG in stylized letters.

Manufactured by USG Interiors, LLC
550 West Adams Street
Chicago, IL 60661

Compositions

™

Decorative Clouds

Installation