TruXedo Deuce Covers manufactured before 12/17/12 - Manual (Page 5)

___ 5 ___
strIker pIn off-center strIker pIn centereD strIker pIn off-center
14
adjust striker: Align striker pin with rotary lock latch and tighten fasteners. Cover will not latch
unless rotary lock latch is centered over striker pin.
striker pin
rotary lock latch striker pin
rotary lock latch
striker pin
rotary lock latch
sIde RaIL and coveR InstaLLatIon (continued)
tighten fastener
16
adjust tension if necessary.
With cover closed, unlatch and
open front of cover. Loosen
nuts and adjust cover forward or
backward. Retighten nuts.
slide
header
this
way
to increase
tension
adjust tensIon IF necessaRy
15
close cover: Unroll cover toward tailgate and rest bows on side rails. Rotate header into header
stops and press down to lock toggle into header. Release cover: Pull back on toggle. Roll cover
toward cab to open. For best results, leave cover fastened to side rails while opening.
header
cover
toggle
header seal
header stop
lock toggle into header
header
seal inside
tailgate
closing cover and tailgate: For best perfor-
mance close cover first and make sure it is se-
cured in the lock position. Next close the tailgate
against the seal, as shown above.
If tailgate has a key lock, TruXedo ® Deuce is
secured until tailgate is unlocked and opened.
oPen and cLose coveR
t
ailgate