beautypg.com

TruXedo Deuce 2 Nissan Titan User Manual

Nissan titan deuce 2, Caution

background image

1. 1703482 MALE CLAMP

2. 1703481 FEMALE CLAMP

3. 1700369 CAP SCREW 3/8” X 1 3/4”

4. 1700429 FLAT WASHER 3/8”

Item Part # Description

Tighten clamp assemblies securely
on side rails before driving vehicle.

P/N 1117771 Rev A

NISSAN TITAN deuce 2

by TruXedo, Inc.

P.O. Box 1078, 2209 Kellen Gross Dr., Yankton, SD 57078

Phone

: 877- 878-9336 Fax: (605) 664-9304 www.truxedo.com

cAuTION

!

These instructions replace steps 2 and 3 in the Deuce 2 owners manual.

NOTE:

If your Nissan Titan pickup does not have utility tracks, then

install the Deuce 2 side rails as shown in your Truxedo Lo Pro Deuce 2

Owners Manual 1117648.

1

2

Install underbody Rails: Slide 2 female clamp halves (1703481) into the track system as shown below. Using a grease pen, make a mark 30 1/4” back

from the bulkhead. Position the rear of the underbody rail flush with the mark you have made. The underbody rail will sit above the cargo track, seated against

both the inside and top of the pickup bed rail. With the underbody rail in place, insert the bolt through the washer, the male clamp half, and into the female clamp

half that you slid into the track. Tighten clamps to secure underbody rail in place.

To finish installation, continue with step 4 in the Deuce 2 manual.

Clamp half 1703481 is in-

stalled in the Utility Track.

3

30 1/4”

Picture above shows under-

body rail correctly installed to

track system.

Install underbody Rails: Slide 2 additional female clamp halves into the track system behind the underbody rail. Position the front of the side rail end

to end, touching the rear of the underbody rail. The side rail will also sit above the cargo track, against both the inside and top of the pickup bed rail. With the

side rail in place (pushing down to compress the weather seal), insert the bolt through the washer, the male clamp half, and into the female clamp half that you

slid into the track. Tighten clamps to secure the side rail in place. Repeat steps 1 & 2 on Passenger Side.

Underbody rail and

side rail touching

end to end.

Underbody Rail

Side Rail

Utility track

Picture above shows side rail correctly

installed to track system.

(CAB END)

4

1

2