Titus ML IOM - Manual (Page 4)

4
Spring Clip - Attaching to Field Cut Diffuser
1
2
To attach spring clip to field cut diffuser:
1. Start spring clip on side of blade support bar.
2. Use needle nose pliers or screwdriver to
expand spring clip until it hooks over other side of
blade support bar.
Hanger Bracket Mounting Instructions
1
1. Drill through top of blade support with
7/32” drill. Use hole in top of field spacer
as guide for drill.
Note: Blade supports are pre-drilled
under factory spacers at at end of
diffusers
2. Hole in blade support will be used as
clearance hole for inserting screw
through face of diffuser, upward into
hanger bracket.
Field Cut Diffuser Only - All Frame & Border Types
1. Insert #10 screw through face of
diffuser, through hole in blade support
and into foot of hanger bracket above
diffuser.
2. Attach hanger wires (by others).
1. Insert #10 screw through face of
diffuser, through hole in blade support.
Start screw in top of hanger bracket
above diffuser.
Note: See submittal Y-ML for duct
dimension D’.
2. Side diffuser up into duct until
hanger bracket ends are above hem of
duct.
3. Tighten screws to draw diffuser
border snug against ceiling.
Caution: Do not overtighten.
1. Insert #10 screw through face of
diffuser, through hole in blade support.
Start screw in top of hanger bracket
above diffuser.
2. Side diffuser up into mounting
frame until hanger bracket ends are
above channel on inside of mounting
frame.
3. Tighten screws to draw diffuser
border snug against ceiling.
Hanger Bracket
for Border
Types 9A, 9B, 12, 15 Hanger Bracket
for Border
Types 2A, 2B Hanger Bracket
for Frame & Border
Types 3, 4, 6, 7A, 7B, 11
2
1
2
1
3
2
1
3
2