Titus HEPAlert IOM for TLF Diffusers - Manual (Page 2)

HEPA
LERT
Kit Installation Manual
IOM-HEPA-TLF -00
725343-01
09-30-04
2 of 7
Installation
1. Determine and mark hole locations in back pan (see
Figure 1). Before drilling holes, position the base
bracket on back pan to verify alignment of marked
holes to bracket openings. Drill holes and insert
grommet into the 5/8-inch diameter hole.
2. Determine and mark hole locations on HEPA filter
frame (see Figure 2). Before drilling frame holes,
verify the marked holes align directly under the back
pan holes in final installation. Insert grommet into the
5/8-inch diameter hole.
3. Determine LED bracket placement on the back pan.
Drill mounting holes on the side of back pan (see
Figure 3). The holes should be on the side of the back
pan adjacent to the holes drilled in Steps 1 and 2.
Figure 1. HEPA LERT Kit Hole Placement
Figure 2. HEPA Filter Frame Hole Locations
4. Secure the pressure switch and terminal barrier strip
to base bracket using pan head screws and hex nuts
(see Figure 4).
5. Secure base bracket to back pan using self-tapping
screws (see Figure 5).
Figure 3. Hole Placement for LED Bracket
Figure 4. Base Bracket with Pressure Switch and
Terminal Barrier Attached
Figure 5. HEPA LERT Base Attached to Back Pan