Regency Horizon HZI540PB Large Gas Insert - Manual (Page 23)

L540PB-2 / HZI540PB-2 Direct Vent Gas Insert
23
INSTALLATION
10. Bundle excess wires and power cord - with the exception of the
wire marked receiver.
Receiver wire requires enough slack to reach the front right of the
unit to be connected to the receiver.
Secure wires with cable ties installed in previous step.
Additionally secure wires with a wire clip to be installed in location
shown below.
11. Install receiver onto backing plate with 2 screws and plug in
receiver cord shown in Step 8.
12. Connect receiver wire from the wiring harness to the back side of
the remote receiver as shown below
Grommet
Cable Tie
Wire Clip
Left
Right
Cable Tie
Cable Tie
13. Bundle excess receiver wire using the 4th cable tie and secure to
the front right of the fi rebox as shown below.
14. Plug the 10 foot extension cord into the FCM extension cord as
shown below.
15. Install a grommet on power cord near the three prong plug
connection made in previous step and secure to the faceplate as
shown below.
Note: 3 prong plugs should be left behind the faceplate after
installation is completed.