Regency Horizon HZI234E Small Gas Insert - Manual (Page 42)

42
Regency ® HZI234E Direct Vent Gas Insert
MAINTENANCE
FAN REPLACEMENT
1) Unplug the power source.
2) Open the left and right side faceplate panels.
3) Remove the bottom louver by pulling out.
4) Remove the glass door.
a) Pull off the left side spring hook that holds
the door in place. While holding the hook turn it
upside down and place it into the middle opening
on the top side mounting bracket. Repeat for
right side
.
b) Swing the door out 45 degrees and lift up
and out.
5) Remove the crystals.
6) Remove panels, if installed.
7) Lift out the bottom tray.
Spring Hook
Top Mounting Bracket
8) Remove the burner by removing 3 screws.
9) Slide burner forward and lift up and out.
10) Pull off the pilot hood cover.
11) Loosen 2 screws to release pilot hood.
12) Slide pilot hood forward, then pull up and off.