Regency Horizon HZI234E Small Gas Insert - Manual (Page 27)

Regency ® HZI234E Direct Vent Gas Insert
27
INSTALLATION
7) Secure the loose wires into the wire clips above and to the bottom left of
the battery pack as shown in diagram 6.
10) From the left side faceplate panel expose the fan reostat wires from
the sleeve and connect them to the wires from the unit as shown in
diagram 8.
8) Close the right side faceplate panel.
9) Remove the grommet from the bracket on the left side of the unit. See
diagram 7.
6) Peel off the tape from the velcro strips and mount the battery pack to the
velcro on the inside of the right faceplate panel as shown in diagram 5.
Battery Pack
Diagram 5
Diagram 6
Diagram 8
11) Tuck the wires completely into the sleeve and place the supplied cable tie
to the end of it as shown in diagram 9.
Diagram 9
12) Place the grommet removed from step 10 over the sleeve (see diagram
9) and put back in place (see diagram 10).
NOTE: Ensure connectors are tucked in behind the mounting bracket to allow
the side faceplate panel to close easily.
Diagram 10
Grommet
Diagram 7