Regency Horizon HZI234E Small Gas Insert - Manual (Page 32)

32
Regency ® HZI234E Direct Vent Gas Insert
INSTALLATION
OPTIONAL HEARTH TRIM - LOW PROFILE FACEPLATE
1) Align the screw holes on the hearth trim with the screw holes on the
fl anges on the left and right side of the unit. Secure in place using
2 screws on each side as shown in diagram 1.
2) Install faceplate.
a) The Hearth Trim can be adjusted to custom fi t an installation by
pulling apart the top piece from the bottom piece.
b) Cut the top of the bottom piece of the hearth trim to the appropriate
height using a metal cutting blade.
NOTE: The tab bends at the back of the top piece of the hearth trim
should be used as the measuring point to the hearth to measure the
height required.
c) Reattach the top piece of the hearth trim to the cut bottom piece by
fi tting in place.
Top
Piece
Cut Here (top of bottom piece) Example
Cut Mark
Example
Cut Mark
Bottom Piece
2-1/4”
(57mm)
Max.
9-1/4”
(235mm)
Hearth Trim Contents List:
2 #8 Screws
1 Hearth Trim
Customize Hearth Trim:
Hearth Trim Installation:
Completed Hearth Trim Installation:
Diagram 1