beautypg.com

Installation, Proflame remote control receiver installation – Regency Horizon HZI234E Small Gas Insert User Manual

Page 33

background image

Regency

®

HZI234E Direct Vent Gas Insert

33

INSTALLATION

PROFLAME REMOTE CONTROL RECEIVER INSTALLATION

1) Remove faceplate if installed.

2) From the right side of the unit, locate and remove the grommet holding

the on/off switch black and red wires and the battery pack wires.

3) Pull wires back through opening. Access white and green wires from

wire harness.

Disconnect Red and Black from the Green and White wire.

4) Install Remote Receiver into left side opening, secure with two

screws. Holes are pre-punched in frame. Be sure arrow on receiver
is point up.

5) Feed the receiver end of the wire harness under the front edge of

fi rebox from right to left.

Grommet

Remote

Receiver

Green

White

Red

Black