Regency Horizon HZI234E Small Gas Insert - Manual (Page 22)

22
Regency ® HZI234E Direct Vent Gas Insert
INSTALLATION
REFLECTIVE PANEL INSTALLATION
1) Remove the faceplate and glass door if already installed - see
manual for instructions.
2) Remove existing panels from unit.
3) Install the back panel fi rst. Tilt the panel forward - position the bottom
of the panel fi rst. Use care not to scratch or mark the panel on the
pilot shield.
4) Install the left side panel - secure in position with one panel clip and
one screw, as shown in the diagram below.
5) Install the right side panel - secure in position with one panel clip
and one screw.
6) Reinstall glass door - reinstall faceplate.
7) Final installation
Before installation, panels must be handled and cleaned as per instructions noted below:
Black Enamel Panels
•
Black Enamel panels must be inspected for scratches and dimples prior to installation. All claims to be recorded at this time.
Claims for damage after installation will not receive consideration.
•
Black Enamel panels will discolor a little during normal operation. This is normal and should not be considered a defect.
* All hand and fi nger marks MUST be cleaned off with a soft cloth. Use an ammonia based cleaner (ie. glass cleaner) to remove any fi nger-
prints before applying heat to the unit.
Failure to do this will result in burn stain on panels which you will be unable to remove. Not protected by product warranty.