STEMCO Aeris Pre-Prep Axle User Manual

Page 2

Axle Plug Installation

•

Install the axle plug using the axle plug installation tool. The hose goes through the center of
the axle plug which is then inserted into the hole on the installation tool.

•

Align the axle plug with the axle spindle and push leading edge of axle plug into spindle bore.
Next, place the face of the installation tool against the axle plug and using a hammer gently
hit the handle of the installation tool and seat the axle plug flush with the end of the spindle
end. Be careful to drive the axle plug in as straight and even as possible to keep plug from
being cocked in bore.

•

Repeat this step on other end of the axle. May use some lubricant on beads to help aid in
installing axle plug.

•

Secure hose for shipping with tape.

Pre-prep kit numbers are:

“N” spindle axles use A000030
“P” spindle axles use A000060

WARRANTY INFORMATION:
All warranty returns may be sent to:

STEMCO
300 Industrial Blvd.
Longview, TX 75691
Attn: Warranty Dept.

Stemco - USA

Stemco - Canada

TS 16949

P.O. Box 1989

5650 Timberlea Blvd. Unit B

STEMCO, BAT RF, and AirBAT are all registered

Longview, TX 75606-1989

Mississauga, ON L4W 4M6

(903) 758-9981 • 1800-527-8492

(905) 206-9922 • 877-232-9111

FAX: 1-800-874-4297

FAX: 877-244-4555

www.stemco.com