SATEC RGM180 - Manual (Page 22)

BG0509 REV. A2 22
6. Troubleshooting
-
If screen does not respond to touch – perform screen
calibration (see Section 2, Display Setup).
-
If the display does not connect to the remote meter – make
sure that the Modbus and/or IP address specified in the Connection
Manager (see Section 5) match the remote meter address.
-
If the display does not connect through the Ethernet
connection – make sure that the installed IP address is set
correctly (see Section 2, Display Setup > Network Setup). You may
also need to contact your system administrator to obtain a legal
address in a specific network.