SATEC RGM180 - Manual (Page 21)

BG0509 REV. A2 21
5. Meter Selection
Labels
The label name assigned to a device will appear in the lower left of the
screen. The user may change these label names (the actual device being
displayed will appear at the top of the screen in parentheses).
Meter Selection
To change the connection to a
different device, press on the label
name in the lower left of the screen
(in this screen, it is PM172).
The Meter Selection screen will
appear.
Press on the address of the desired
meter. Press OK on the ‘Connection
established’ box. Data display will
begin.
To change the label name or address
of a device, press on Setup. The
Connection Manager screen will
appear. Press on the label name or
address you wish to change.
Note: In most cases, excluding stand-
alone or ethernet connections, there
is no need to change the address or
IP. Connecting to an external device
requires the definition of MODBUS
and/or IP addresses.
To perform display setup from this menu, press RGM Setup. See Section
2 for Display Setup instructions.