SATEC EM920 Installation Manual - Manual (Page 23)

Chapter 2 Installation 17
USB Communication port (USB – on board)
The EM920 provides a standard full speed USB DEVICE port.
The USB DEVICE port connection is provided by the LOGIC/DISPLAY cable terminated with
a standard USB type A connector as shown in figure 19
Figure 21: USB connection
Optional Communication ports
Wireless Communication port – GSM/GPRS module (COM2 –
optional module)
The Wireless Communication port – COM2 is provided by optional module: GSM/GPRS
module.
Before plugging-in the GSM/GPRS module to the meter, insert the SIM card into the SIM
card carrier, then pull the slide to lock the SIM card as shown in figure 20.
1) Push down the SIM carrier slide
2) Insert the SIM card into SIM carrier
3) Push up the SIM carrier slide to lock the SIM card
Figure 22: GSM/GPRS module – SIM card assembly