SATEC EM920 Installation Manual - Manual (Page 2)

ii
DANGER
This symbol indicates the presence of dangerous voltage within and outside the
product enclosure that may constitute a risk of electric shock, serious injury or death
to persons if proper precautions are not followed.
CAUTION
This symbol alerts the user to the presence of hazards that may cause minor or
moderate injury to persons, damage to property or damage to the device itself, if
proper precautions are not followed.
NOTE
This symbol directs the user’s attention to important installation, operating and
maintenance instructions.
LIMITED WARRANTY
The manufacturer offers the customer a 24-month functional warranty on the instrument for
faulty workmanship or parts from date of dispatch from the distributor. In all cases, this
warranty is valid for 36 months from the date of production. This warranty is on a return to
factory basis.
The manufacturer does not accept liability for any damage caused by instrument malfunction.
The manufacturer accepts no responsibility for the suitability of the instrument to the
application for which it was purchased.
Failure to install, set up or operate the instrument according to the instructions herein will void
the warranty.
Only a duly authorized representative of the manufacturer may open your instrument. The unit
should only be opened in a fully anti-static environment. Failure to do so may damage the
electronic components and will void the warranty.
NOTE
The greatest care has been taken to manufacture and calibrate your instrument. However,
these instructions do not cover all possible contingencies that may arise during installation,
operation or maintenance, and all details and variations of this equipment are not covered by
these instructions.
For additional information regarding installation, operation or maintenance of this instrument,
contact the manufacturer or your local representative or distributor.
DANGER
Failure to observe the following instructions may result in severe injury or death.
Read the instructions in this manual before performing installation, and take note of
the following precautions:
1. Ensure that all incoming AC power and other power sources are turned OFF before
performing any work on the instrument. Failure to do so may result in serious or even fatal
injury and/or equipment damage.
2. Before connecting the instrument to the power source, check the labels on the front of
the instrument to ensure that your instrument is equipped with the appropriate power supply
voltage, input voltages and currents for your application.
3. Do not connect the instrument to a power source if it is damaged.
4. Do not expose the instrument to rain or moisture.
5. The secondary of an external current transformer must never be allowed to be open
circuit when the primary is energized. An open circuit can cause high voltages, possibly
resulting in equipment damage, fire and even serious or fatal injury. Ensure that the current
transformer wiring is made through shorting switches and is secured using an external strain