SATEC C191HM - Manual (Page 8)

v
SETUP (see Chapter 4 for full instructions)
Setups can be performed directly on the front panel
or via PComTest communication software.
Press .
Press to activate middle window.
Press
⇑ ⇓ to scroll to desired option.
Press to activate lower window.
Press
⇑ ⇓ to scroll to desired value.
Press to save selected value.
Basic and Communications Default Setups
Code Parameter Options Description
ConF Wiring mode 4Ln3 4-wire Wye using 3 PTs (3 element), line to
neutral voltage readings
Pt PT ratio 1.0 The phase potential transformer ratio
Ct CT primary current 5 The primary rating of the phase current
transformer, A
d.P Power demand
period 15 The length of the demand period for power
demand calculations, in minutes. E = external
synchronization
n.dp Number of power
demand periods 1 The number of demand periods to be averaged
for sliding window demands
1 = block interval demand calculation
A.dP Ampere/Volt
demand period 900 The length of the demand period for
volt/ampere demand calculations, in seconds
0 = measuring peak current
buF Averaging buffer
size 8 The number of measurements for RMS sliding
averaging
rSt Reset
enable/disable diS Protects all reset functions, both via the front
panel or communications.
Freq Nominal frequency 50/, 60 The nominal power utility frequency, Hz
LoAd Maximum demand
load current 0 The maximum demand load current used in
TDD calculations (0 = CT primary current)
Prot Communications
protocol ASCII
ASCII protocol
Addr Address 0 (ASCII) Powermeter address
bAud Baud rate 9600 9600 bps
dAtA Data format 8n 8 bits, no parity
CPtb ASCII compatibility
mode diS Disables ASCII compatibility mode (For more
information, see ASCII Communications
Protocol Reference Guide)
Port
ASCII
Prot
menu
option
value
bASc
4L-n
ConF
menu
option
value
SELECT CHG ENTER
SELECT
SELECT
ENTER