Salsbury Industries 4750 Mail Houses Wall Mounted - Manual

Mail Houses – 4750
Wall Mounted Installation Instructions
Made of electro-galvanized steel sheet with a durable powder coat finish and a stainless steel mail flap, Salsbury 4750 mail houses will provide years
of maintenance free service.
Mounting Mail House to a Flat Wall
1. The installation fasteners are not provided due to the variation in
wall types to which the mailbox might be mounted. Select fasteners
and anchors appropriate for the type of wall.
2. Mounting access is provided by opening the mail flap and mail
access door.
3. Where possible, it is best to shield the mailbox from direct
weather conditions.
4. Contact your local U.S.P.S. office for the required height of the
mailbox on the wall.
5. Using the template provided, mark the location of the 4 holes on
the back of the mailbox. Drill the 4 mounting holes as marked.
6. Holding the mailbox aligned horizontally in the mounting position,
mark on the wall the position of the 4 mounting holes in the back wall
of the mailbox.
7. Attach the mailbox to the wall using the appropriate fasteners.
Note: Mounting holes are not pre-drilled into the Mail House as this
unit can be installed on a mailbox post.
Cleaning
Interior & Painted Exterior – Using a soft cloth or sponge, clean the
interior and painted exterior of the mailbox with liquid soap,
detergent, or diluted water-soluble household cleaners. Completely
remove residue of any cleaning products with water, and thoroughly
dry with a clean cloth or paper towel.
Stainless Steel Mail Flap – The mail flap may be cleaned as
indicated above. Be sure to scrub and polish satin finish materials in
the same direction as the grain of the stainless steel. DO NOT use
abrasive materials on stainless steel surfaces.
4750 Mail House
4750 Mounting Dimensions
SALSBURY INDUSTRIES
1010 East 62 nd Street, Los Angeles, CA 90001-1598
Phone: 1-800-624-5269 Int’l Phone: 323-846-6700
Fax: 1-800-624-5299 Int’l Fax: 323-846-6800
www.mailboxes.com engineering @ mailboxes.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2010 Salsbury Industries. All rights reserved. (Rev. 01, 10/27/2010) Page 1 of 5