Salsbury Industries 4850 Heavy Duty Rural Mailboxes Standard Mailbox Post - Manual (Page 3)

SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: 1-800-624- 5269 Int’l Phone: 323-846-6700
Fax: 1-800-624- 5299 Int’l Fax: 323-846-6800
www.mailboxes.com engineering @ mailboxes.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2014 Salsbury Industries. All rights reserved. (Rev. 05, 1/23/14)
Heavy Duty Rural Mailboxes
– 4850
Deluxe Mailbox Post Installation Instructions
U.S.P.S. APPROVED
Thank you for selecting Salsbury Industries 4850 heavy duty rural mailbox. This instruction sheet is for installing the 4850 heavy duty rural mailbox on a Salsbury
deluxe mailbox post. A different instruction sheet is available for installing mailboxes on a bridge style deluxe mailbox post. Other installation instructions are
available for installing the mailboxes on a standard mailbox post or on a decorative mailbox post, installing the mailbox on spreaders, mounting a newspaper holder,
and mounting the post in a concrete footing.
When you install a curbside or roadside mailbox, make sure that it is easily accessible to the mail carrier. By regulation it should be 41” to 45” from the ground or
street surface up to the inside floor of the mailbox. The door should be set back 6” to 8” from the front face of the curb or the road edge. However, you should check
with your local postmaster to ensure that the mailbox is installed according to local regulations.
All hardware required to assemble the mailbox(es) to the deluxe mailbox post is provided with the post. Each mailbox requires four (4) 5/16”-18 x 2” long pan head
bolts and four (4) 5/8” nylon spacers to attach to the post arm(s). The 5/8” nylon spacers are placed between the bottom surface of the mailbox and the top surface
of the post arm. Open the front door of the mailbox and install the four (4) 5/16”-18 x 2” long pan head bolts through the four (4) square holes in the inside floor of the
mailbox, through the four (4) 5/8” nylon spacers (thread onto bolt), and into the four (4) tapped holes in the arm of the deluxe mailbox post. Additional hardware
provided is not needed and may be discarded.
4870 Deluxe Mailbox Post
Note: On the 4870 deluxe mailbox post, the longer mounting arm which
accommodates the mailbox can be on either the left or right side. When
attaching the post to the ground, position the post so the longer mounting
arm is on the side desired. Then mount the mailbox on the mounting arm
with the mailbox facing the street or roadway.
4872 Deluxe Mailbox Post
4873 Deluxe Mailbox Post
Note: On the 4873 deluxe mailbox post, the mounting arms can be
positioned on either side of the vertical post.
4874 Deluxe Mailbox Post