Salsbury Industries 3700 Series Horizontal Mailboxes PARCEL LOCKER DOOR ARROW LOCK - Manual

SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Ph: 1-800-624-5269 Int’l Ph: 323-846-6700
Fx: 1-800-624-5299 Int’l Fx: 323-846-6800
www.mailboxes.com [email protected]
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2011 Salsbury Industries. All rights reserved. (P/N 370135, Rev. 10, 6/21/11) Page 1 of 2
PARCEL LOCKER DOOR ARROW LOCK
3700 Series Horizontal Mailboxes
Installation Instructions
This installation instruction document is for installing the USPS Arrow lock and two lock covers in a parcel locker door on the 3700 series Horizontal
Mailboxes.
Note
The mail receptacle is shipped without a USPS Arrow lock installed
in the parcel locker door. This lock must be requested from the
USPS and installed by USPS personnel. Call your local post office to
request this service.
Installation
Step 1
Check that the tenant lock cam is pointed upward. Use the tenant
lock key to unlock the tenant lock if necessary. Remove the four (4)
locknuts from the four (4) captive bolts. Do not remove the loose
spacer plate.
Step 2
Install the Arrow lock over the four (4) captive bolts with the Arrow
lock bolt facing upwards. The spacer plate should be between the
Arrow lock and the mounting box. Install and tighten the four (4)
lock nuts. DO NOT OVERTIGHTEN. Check the locking mechanism
for proper operation. See “To Check Locking Mechanism”
instructions on next page.
Step 3
Install the tenant lock cover. Use the three (3) one-way screws to
secure the tenant lock cover.