Salsbury Industries 3700 Series Horizontal Mailboxes ACCESS DOOR ARROW LOCK User Manual
Installation instructions

SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: 1-800-624-
5269 Int’l Phone: 323-846-6700
Fax: 1-800-624-
5299 Int’l Fax: 323-846-6800
www.mailboxes.com engineering
@
mailboxes.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2013 Salsbury Industries. All rights reserved. (P/N 370136, Rev. 07, 8/26/13) Page 1 of 2
ACCESS DOOR ARROW LOCK
3700 Series Horizontal Mailboxes
Installation Instructions
This installation instruction document is for installing the USPS Arrow lock in the access door on the 3700 series Horizontal Mailboxes.
Note
The mailbox is shipped without a USPS Arrow lock installed in the
access door. This lock must be requested from the USPS and
installed by USPS personnel. Call your local post office to request
this service.
Installation
Step 1
Open the access door. Remove six (6) preinstalled locknuts and
remove the backup plate, the spacer plate and the door stiffener
bracket.
Step 2
Install the spacer plate against the stiffener bracket aligning its four
(4) holes with the four (4) holes on the stiffener bracket.
Step 3
Install the Arrow lock onto the stiffener bracket by sliding the lock bolt
through the latch slot. Align the four (4) holes of the Arrow lock with
the four (4) holes of the spacer plate and stiffener bracket.