Salsbury Industries 19900 Free-Standing Enclosures For 19000/19100 Series Recessed Mounted Cell Phone Lockers - Manual (Page 2)

SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: 1-800-624- 5269 Int’l Phone: 323-846-6700
Fax: 1-800-624-5299 Int’l Fax: 323-846-6800
www.lockers.com www.mailboxes.com engineering @ mailboxes.com [email protected]
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2013 Salsbury Industries. All rights reserved. (Rev. 02, 9/16/2013) Page 2 of 2
19900 Free-Standing Enclosures
For 19000/19100 Series Recessed Mounted Cell Phone Lockers
Installation Instructions
Installing Recessed Cell Phone Locker – without
Front Access Panel
Install the locker unit into the enclosure by sliding it into the enclosure
until its front peripheral flange is flush against the front of the
enclosure. Open the four corner compartments of the cell phone
locker. Install #8 x 1-1/4 in. long screws (provided) through the top
and bottom of the locker unit into the enclosure. Close the
compartment doors.
Installing Recessed Cell Phone – with Front Access
Panel
Install the locker unit into the enclosure by sliding it into the enclosure
until its front peripheral flange is flush against the front of the
enclosure. Open the front panel access compartment of the cell
phone locker then open the front panel. Install #8 x 1-1/4 in. long
screws (provided) through the slots in the sides of the front
peripheral flange of the locker unit into the enclosure. Close the front
panel then the front panel access compartment.