Salsbury Industries S-66000 Series See Through Box Style Bridge Lockers - Manual (Page 3)

SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: 1-800-562-5377 Int’l Phone: 323-846-6700
Fax: 1-800-562-5399 Int’l Fax: 323-846-6800
www.lockers.com engineering @ lockers.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2012 Salsbury Industries. All rights reserved. 2/8/2012
See-Through Box Style Bridge Lockers
Locker Benches
Assembly & Installation Instructions
Thank you for selecting Salsbury’s 77770 series locker aluminum benches. We are confident that the quality and construction of this product will provide years of
maintenance free use.
Preliminary Notes
There are two basic steps to assembly and installation:
1. The bench pedestals must be assembled to the bench top.
2. The bench assembly must be bolted to the floor.
Failure to bolt the bench assembly to the floor could result in injury to
persons sitting on the bench.
Since various types of floors require different types of fasteners, floor
installation hardware is not provided. The hardware provided is for fastening
the bench pedestals to the bench top.
Two bench pedestals are provided for each bench top. Each bench pedestal
should be installed 6” from the end of each side of the bench top.
Assembly
Install one of the 5/16” by 1-1/4” long carriage bolts through a straddle clamp
and loosely attach it to the bench pedestal with one of the 5/16” serrated
flange nuts as shown in Figure 1. The straddle clamps should be installed
on the end of the bench pedestal with the smaller plate. Do this with the
remaining three straddle clamps in the first bench pedestal and repeat for the
four clamps in the second bench pedestal.
Set the bench top on a flat surface upside down. Rotate each of the straddle
clamps on a bench pedestal aligned such that they can be inserted into the
bottom of the bench top as shown in Figure 2. Rotate them each 90 degrees
so that they straddle and grip the inside lips of the bench top when the nuts
are tightened as shown in Figure 3. Ensure that the straddle clamps are
aligned with the lips. Also ensure that the square section of the carriage
bolts are inside the square slots in the straddle clamps. Tighten the nuts
until the clamps are not quite gripping the lips inside the bench top. Slide the
bench pedestal to a position 6” from one end of the bench top. Adjust the
position of the bench pedestal so that it is centered crosswise under the
bench top and tighten the nuts securely.
Repeat for the other bench pedestal, installing it 6” from the other end of the
bench top.
Complete the installation by fastening the assembled bench to the
floor.