Salsbury Industries 62000 Series Standard Lockers Double Tier - Manual (Page 3)

Standard Lockers – 62000 Series
Double Tier Installation Instructions
Phone: 1-800-562-5377 Int’l Phone: 323-846-6700
Fax: 1-800-562-5399 Int’l Fax: 323-846-6800
www.lockers.com [email protected]
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2014 Salsbury Industries. All rights reserved. Page 3 of 5 3/27/14
SALSBURY INDUSTRIES
1010 East 62 nd Street, Los Angeles, CA 90001-1598
Three Wide Locker Assembly (continued)
Step 7: Attach the last side panel and the right rear leg to the assembly of Step 6.
Attach two additional single coat hooks to the last side panel. The locker chassis is
now complete.
Step 8: Position the pre-assembled door frames onto the assembly of Step 7 then
fasten one by one.
Step 9: Tighten all fasteners checking for squareness of the locker while tightening.
Attach optional sloping hoods, end bases or front bases (see pages 4 and 5).
Step 10: Place the locker in the installed location and anchor to the floor, wall, or to
both. Individual job conditions will dictate the type of fastening anchors to use (not
provided).
Step 11: Fasten all lockers in a row together by installing fasteners (provided) through
the side panels. Installation is now complete.