Robustel M1000 XP User Guide - Manual (Page 51)

Robustel GoRugged M1000 XP User Guide
RT_UG_M1000 XP_v.1.0.0
19.11.2013 50 / 57
Confidential
remote serial devices or modems.
The purpose of the redirector is to make the virtual COM port exhibit behavior that closely resembles that of a "real"
COM port, i.e., a COM port driver for local serial port hardware. A virtual COM port itself is a relatively simple
software mechanism that can be implemented by driver software similar to that of a conventional COM port driver.
The main challenges arise in two other areas: the network connection to the device server and the behavior of the
device server. These issues are described in the Technology section below.
Chapter 5. Appendix
5.1 Factory Settings
Factory setting of the gateway COM port under Config Mode and Normal Mode is:
Data bits = 8
Parity = none
Stop bits = 1
Baud = 115200 bps
Flow control = none
5.2 M1000 XP SMS Command for Remote Control
5.2.1 SMS Commands Structure
M1000 XP supports remote configuration and remote gateway status reading via SMS.
An SMS command has the same structure as the CLI command: Password: command
 Password: SMS control password is configured at NMS->SMS Control->Password, which is an optional
parameter.
 Command: please check all the SMS commands in section 5.2.3, usually we will want to get exiting settings
(use “get” command) or set new parameters (use “set” command) of M1000 XP.
 When there is a password, SMS command has following structure: Password: command
 When there is no password, SMS command has following structure: command
5.2.2 SMS Control Steps
1. Send the first SMS command to M1000 XP: Password: command or command;
2. If the first SMS command is used to configure new parameter, remember to send the second SMS commands
“save”, and third SMS commands “reboot” to save new settings and reboot M1000 XP.