Robustel M1000 XP User Guide - Manual (Page 23)

Robustel GoRugged M1000 XP User Guide
RT_UG_M1000 XP_v.1.0.0
19.11.2013 22 / 57
Confidential
Connect
Connect the M1000 XP Configurator to the gateway, which
will use the PC’s local RS-232 port.
Disconnect
Disconnect the M1000 XP Configurator to the gateway and
release the PC’s RS-232 port.
Read Read gateway’s current settings.
Write
Save changes into gateway.
Note: Some parameters changes need to reboot to take
effect.
Default Set gateway to default factory settings.
Reboot Reboot the gateway.
Exit Exit the M1000 XP Configurator.
Disconnecting
Gateway is not communicating with M1000 XP
Configurator.
Connecting Gateway is communicating with M1000 XP Configurator.
Serial Management Settings
Show the current RS-232 management communication
parameter.
TCP Management Settings
Show the current TCP management communication
parameter.
Versions Show the gateway’s current firmware version.
Important Notice
You must save your parameter changes by clicking “Write” button and then reboot your M1000 XP by clicking
“Reboot” button to take effect for the parameter changes.
3.5 Export and Import Profiles
Users could export gateway settings from one gateway, and then import the same settings to other gateways, which
makes it convenient to carry out “mass deployment” and “pre-configuration”.
1. Select Export from the Settings menu. Then select a folder and enter the file name for the profile. Click on Save,
then it will popup “Export Succeed” windows.