beautypg.com

13 configuration -> serial, Configuration -> serial – Robustel R3000 NU User Manual

Page 36

background image

Robustel GoRugged R3000 NU User Guide


RT_UG_R3000 NU_v.1.0.0 24.03.2014 35 / 110
Confidential

R3000 NU connects to.

Mode

Show current mode of R3000 NU: AP or Client.

Null

Key Management

Show current security mode of R3000 NU or the access point which
R3000 NU connects to.

Null

Cipher Pairwise

Show current encryption algorithm of R3000 NU or the access point
which R3000 NU connects to.

Null

Cipher Group

WPA State

Show current WPA status. Mainly there are 5 statuses: Disconnected,
Scanning, Initializing, Associated, 4way_handshark, Completed.
Disconnected: Not associated or connected with any access point,
perhaps because the wireless device has not fully initialized, is out of
range, or the wireless interface is disconnected because the Ethernet
interface is enabled.
Scanning: Searching for a wireless network (access point) for
connection.
Initializing: R3000 NU is setting up initial wireless environment.
Associated: This state is entered when the driver reports that
association has been successfully completed with an AP, but still waiting
for authentication.
4way_handshark: This state is entered when WPA/WPA2 4-Way
Handshake is started. When Passphrase do not match, it will show this
status.
Completed: The wireless connection of R3000 NU and other wireless
devices are established.

Null

Address

Show the MAC address of R3000 NU’s WiFi interface.

Null

Associated Clients @ AP
mode

Show current associated wireless client devices’ BSSID and IP address.

Null

Scan Results @ Client
mode

Show current scan results of any wireless network (access point), such
as SSID, Channel, Signal Level, Flags (the security mode and encryption
algorithm flags of access point).

Null

3.13 Configuration -> Serial

This section allows users to set the serial (RS232/RS485) parameters.