3 commands reference, Commands reference – Robustel R3000 NU User Manual
Page 110
Robustel GoRugged R3000 NU User Guide
RT_UG_R3000 NU_v.1.0.0 24.03.2014 109 / 110
Confidential
ICMP detection retries : 3
reset the interface : no
*********************************************
R3000 NU # configure
R3000 NU (config) # set eth0
ethernet interface type: WAN
type select:
1. Static IP
2. DHCP
3. PPP0E
->please select mode (1-3) [1]:
->IP address [192.168.0.1]:58.1.1.1 //set IP address for eth0
->Netmask [255.255.255.0]:255.0.0.0
->gateway [192.168.0.254]:58.1.1.254 //set gateway for eth0
->mtu value (1024-1500)[1500]:
->input primary DNS [192.168.0.254]:58.1.1.254 //set dns for eth0
->input secondary DNS [0.0.0.0]:
this parameter will be take effect when reboot!
really want to modify[yes]:
R3000 NU (config) # end
R3000 NU# write //save current configuration
Building configuration...
OK
R3000 NU # reload
! Reboot the system? 'yes' or 'no': yes //reload to take effect
5.3 Commands reference
commands
syntax
description
Debug
Debug parameters
Turn on or turn off debug function
Export
Export parameters
Export vpn ca certificates
Import
Import parameters
Import vpn ca cerfiticates
Syslog
syslog
Export log information to tftp server
Load
Load default
Restores default values
Write
Write
Save current configuration parameters
tftp
Tftp IP-address get {cfg|rootfs}
file-name
Import configuration file or update firmware via tftp
Show
Show parameters
Show current configuration of each function , if we need to see
all please using “show running ”