Robustel R3000 NU - Manual (Page 108)

Robustel GoRugged R3000 NU User Guide
RT_UG_R3000 NU_v.1.0.0 24.03.2014 107 / 110
Confidential
5.2 How to configure the CLI
Following is a list about the description of help and the error should be encountered in the configuring program.
Commands /tips Description
? Typing a question mark “?” will show you the help information.
Ctrl+c
Press these two keys at the same time, except its “copy” function but also
can be used for “break” out of the setting program.
Invalid command “xxx”
Parameters “xxx” are not supported by the system, in this case, enter a mark
“?” instead of “xxx” will help to find out the correct parameters about this
issue.
Incomplete command Command is not incomplete.
% Invalid input detected at '^' marker '^' marker indicates the location where the error is.
Note: Most of the parameters setting are in the
Global configuration mode. Commands set ,add are very important
for this mode. If some parameters can’t be found in the Global configuration mode, please move back to Privileged
exec mode or move up to Interface mode.
Note: Knowing the
CLI hierarchy level modes is necessary before configuring the CLI. If not, please go back
and read it quickly in chapter 5.
5.2.1 QuickStart with configuration examples
The best and quickest way to master CLI is firstly to view all features from the webpage and then reading all CLI
commands at a time , finally learn to configure it with some reference examples .
Example 1: Show current version
R3000 NU> show version
software version : 1.01.00
kernel version : v2.6.39
hardware version : 1.01.00
Example 2: Update firmware via tftp
R3000 NU> enable
Password: *****
R3000 NU#
R3000 NU# tftp 172.16.3.3 get rootfs R3k.1.01.00.02_130325
Tftp transfering
tftp succeeded!downloaded
R3000 NU# write //save current configuration