Retsch ZM 200 - Manual (Page 5)

08.02.2012 Retsch GmbH
5
0003
Safety directive summarised, part 1
Safety instructions
We reject herewith any and all claims relating to personal injury or material damage which result
from the failure to comply with the following safety instructions.
Intended use
Do not make any modifications to the machine and only use Retsch approved spares and
accessories.
The conformity to the European guidelines declared by Retsch otherwise loses its
validity. It furthermore leads to the loss of all warranty claims.
Packaging
Please retain the packaging for the duration of the warranty since, in case of complaint, returning in
unsuitable packaging can jeopardize your warranty claims.
Transport
During transportation, do not subject the ZM200 to impacts, jolts or vibrations. The electronic and
mechanical components could otherwise be damaged.
Temperature fluctuations
In case of wide temperature fluctuations (during shipment by air, for instance), protect the ZM200 from
condensation. The electronic components could otherwise be damaged.
Scope of supply
If the shipment is incomplete and / or has suffered transport damage, you must notify the forwarder and
Retsch GmbH immediately (within 24 hours). Under certain circumstances, claims lodged at a later date
may not be considered valid.
Ambient temperature :
When the ambient temperature exceeds or falls below that specified, the electronic and mechanical
components may be damaged, and performance data changed to an unknown extent.
Air humidity :
At a higher air humidity, the electronic and mechanical components may be damaged, and performance
data changed to an unknown extent.
Electrical connection / connecting the power
Failure to observe the values on the data plate can cause damage to electronic and mechanical
components.
Inserting the grinding tools
Set the openings for the torsion lock on the collecting vessel and the ring sieve over the torsion lock pin.
Otherwise the ZM200 cannot be started.
When cold grinding, do not forcibly remove the plug-on rotor, which jams easily for physical reasons, but
rather wait for the temperature to level out.
Forced removal causes damage to the motor shaft and the rotor.
Do not forget to re-install the cassette cover.
Without the cassette cover, the motor is blocked by the thrust pins in the housing cover.