Retsch SM 100 - Manual (Page 31)

Cleaning and service
31
The cutting gap must be checked to ensure that the device is functioning
satisfactorily (target distance 0.3mm). For this reason the cutting bars (
SL) are
arranged so that they can be shifted to permit adjustments to the cutting gap.
Fig. 15: Access to the cutting bars
• Unscrew the four screws on the left-hand cover [
1]..
• Unscrew the three screws on the right-hand cover [
2].
• Open the grinding area door.
• Pull the rotor approx. 10 mm out of the grinding area until it can be freely
rotated.
U
U
W
W
W
1 2
3 4