Retsch SM 100 - Manual (Page 30)

Cleaning and service
30
Fig.4: On/off switch
You can switch the device on/off using the on/off switch (
G). The motor starts up
or is shut down when the switch is actuated. The switch disconnects the device
from the mains.
Pos : 7. 25 /00005 Ü berschrif ten/ 1. 1 Ü bersc hrift en/ 1. 1 Übersc hrift en BD A/ 11 Mahl vorgang s tart en @ 0\ mod_1227185008190_9. doc @ 3861 @ @ 1
5.8 Starting the grinding process
Pos : 7. 26 /00010 Bedi enungsanleit ung en Kapitels ammlungen/ SM100/ 0015 SM 100 Bedi enung/1545 SM 100 M odul M ahl vorgang st art en @ 3\ mod_1284973923382_9.doc @ 23728 @ @ 1
NB
Only fill test material when the device is running because this may otherwise lead
to motor blockages when starting the device.
The cutting gap between the rotor and cutting bar must be checked after each
grinding operation with hard materials. The maximum cutting gap may be 0.5 mm
(minimum is 0.3 mm).
(See chapter on Adjusting the cutting bars)
Fig. 8: Cutting gap
Pos : 7. 27 /00005 Ü berschrif ten/ 1. 1 Ü bersc hrift en/ 1. 1 Übersc hrift en BD A/ 11 Mahl vorgang s toppen @ 0\ mod_1226909892231_9.doc @ 3643 @ @ 1
5.9 Stopping the grinding process
Pos : 7. 28 /00010 Bedi enungsanleit ung en Kapitels ammlungen/ SM100/ 0015 SM 100 Bedi enung/1550 SM 100 M odul M ahl vorgang st oppen @ 3\ mod_1284973924085_9. doc @ 23737 @ @ 1
The grinding process in progress can be stopped by actuating the on/off switch.
The grinding area door can now be opened.
Pos : 8. 1 / 00005 Übersc hrift en/1. Übersc hrift en/1 Rei nigung und Wart ung @ 0\ mod_1231167007723_9.doc @ 5450 @ @ 1
6 Cleaning and service
Pos : 8. 2 / 00005 Übersc hrift en/1. 1 Ü berschrif ten/ 1. 1 Ü bers chrift en BDA/ 11 Schneidl eist en ei nst ellen @ 2\ mod_1264610496967_9. doc @ 18737 @ @ 1
6.1 Adjusting the cutting bars
Pos : 8. 3 / 00010 Bedienungsanlei tungen Kapit elsamml ung en/SM 100/ 0040 SM100 Wart ung, R einigung und Versc hleiß /4005 SM 100 M odul Sc hneidl eist en ei nst ellen @ 3\ mod_1284982610681_9.doc @ 23836 @ @ 1
G