Retsch SK 100 - Manual (Page 9)

05/04/2012

Retsch GmbH
9
0002
Transport and setting up
Target groups: Operators, forwarders,
users
Packing
The packing is adjusted to the transport
route. It complies with the generally
applicable packing regulations.
Please keep the packing for the whole of the guarantee period. If,
in the case of a complaint, the unit is returned in inadequate pack-
ing, your guarantee rights may be jeopardised.
Fig.1
Transport
Use the ring bolt H to transport the SK 100. Fig.1
The SK 100 may not be subjected to shocks, shaken or thrown
during transport. Otherwise the electrical and mechanical com-
ponents may be damaged.
Temperature fluctuations
In the case of major temperature fluctuations (e.g. with transpor-
tation by air), the SK 100 must be protected against condensation.
Otherwise the electronic components may be damaged.
Intermediate storage
Ensure that the SK 100 is also kept dry when
subject
to intermediate storage.
Parameters for setting-up location
Ambient temperature
The ambient temperature should be be-
tween 5°C and 40°C.
When the ambient temperature exceeds or falls below that specified,
the electronic and mechanical components may be damaged, and per-
formance data changed to an unknown extent.
Relative humidity
Maximum relative humidity 80% at tem-
peratures up to 31°C,
falling in linear fashion down to 50% rela-
tive humidity at 40°C
At higher humidity, the electronic and mechanical components may
be damaged, and performance data changed to an unknown extent.