Retsch SK 100 - Manual (Page 6)

05/04/2012

Retsch GmbH
6
0002
Technical Data
Machine type designation: SK 100
Application with proper use
SK 100 standard
For uses where primarily the same materials are to be ground in larger
quantities and it is not absolutely necessary to open the door after every
grinding operation to clean the grinding chamber.
SK 100 comfort
For uses where always different materials are to be ground and it is neces-
sary to open the door after every grinding operation to clean the grinding
chamber.
Do not make any modifications to the machine and use only RETSCH approved spares and
accessories.
Failure to comply will invalidate the CE declaration and guarantee.
This unit is not designed as a production machine, but as as laboratory de-
vice intended for 8 hours single shift operation.
Both types crush medium-hard to hard and brittle materials with a hard-
ness of about 6 according to Mohs.
They are conceived especially for crushing the following materials:
ashes drugs ores animal feed
rocks glass resins potassium
coal coke grains artificial resins
minerals pellets salts slags
bricks bauxite gypsum pyrites
and many other, similar materials.
The achievable end fineness depends on the hole width of the bottom
sieve and the grinding properties of the material to be ground. In favour-
able cases, finenesses of <100µm can be achieved.
For further information, our application laboratory is at your disposal.
Drive
SK100 standard
1 and 3 phase AC motor
SK100 comfort
1 and 3 phase AC motor with brake
Speed
2850min -1
Rated power
1100 Watt