Retsch SK 100 - Manual (Page 15)

05/04/2012

Retsch GmbH
15
0002
Filter hose and collecting vessel
Fig.8
Fig.9
With the use of a fabric filter hose between the SK 100 and col-
lecting vessel, the air stream arising due to the rotating cross
beater is taken off and this prevents a jam. Furthermore, it speeds
up the material throughput and ensures a gentle crushing process.
* Push filter hose E over the flange and at the same time
hold the clamping clip at an angle
* Clamp seal E1
* Hang in collecting vessel F
* Clamp seals F1
If the collecting vessel is mounted without filter hose, it must be
expected that dust will be emitted from the filling funnel D.
Feed material to be crushed
The maximum feed grain size should not exceed 20mm.
For batch or continuous operation, the SK 100 can be retrofitted
with a 30 l plastic container and a DR 100/75 vibratory feeder as
accessories.
* Feed material slowly into the filling funnel D Fig. 9
A rebound safety device fitted in the filling funnel prevents the
material being crushed from being thrown back.
Feed material slowly and continuously into the filling funnel.
An excessive feed quantity may force the SK 100 to come to a
standstill and mechanical components may be damaged.
!
During crushing, material in dust form may escape from the filling fun-
nel. In the case of toxic and otherwise health-impairing materials, use an
extractor.
Danger if health-hazardous dust is inhaled.
!
Some materials form explosive mixtures.
Check the material properties of your crushing device.
Danger of explosion.