Retsch SK 100 User Manual
Page 13
05/04/2012
Retsch GmbH
13
0002
Control elements and their function
Overview Fig.4
Item
Element
Symbol
Function
A
Power switch with
ON/OFF button
0 I
Isolates the SK 100 from and connects it with the power supply
I pressed = SK 100 is switched on
0 pressed = SK 100 is switched off
A1
Power switch with
knob
Isolates the SK 100 from and connects it with the power supply
ON = SK 100 is switched on
OFF = SK 100 is switched off
B
Door seal
cylinder-head screw
only with SK 100
standard
Opens and seals the door of the SK 100 standard, tensions the door
seal
clockwise = seals the door
anticlockwise = opens the door
Tool needed = Spanner C
B1
Door seal
handwheel only
with
SK 100 comfort
Opens and seals the door of the SK 100 comfort, tensions the door
seal
Pressed in and turned clockwise = seals the door
Pressed in and turned anticlockwise = opens the door
C
Key for door seal
B,
only with
SK 100 standard
Is needed to open and close the door seal with the cylinder head
screw on the SK 100 standard
D
Filling funnel at
door
Takes the material to be crushed with a maximum grain size of
20mm; does not serve to store material;
Reliably prevents material being crushed from flying out.
E
Filter hose
o. Fig.
Prevents build-up of the air pressure caused by rotating cross beater
and thus accelerates material throughput.
F
Collecting vessel 5l
o. Fig.
Takes crushed material.
G
Release lever for
motor brake only
with
SK 100 comfort
When pushed back, makes it possible to release the motor brake and
thereby allows manual turning of the cross beater for cleaning pur-
poses.
H
Transport bolt
Prevents damage to mechanical and electrical components during
transport
I
Adjusting screws on
base frame
Make it possible to align the base frame on uneven floor
When screwed out, they expose the openings which permit fastening
of the base frame to the floor, Ø10mm