Retsch SK 100 - Manual (Page 14)

05/04/2012

Retsch GmbH
14
0002
Opening and closing of the mill
housing
0 I
Fig.5
0 I
Fig.6
SK 100 standard
Only open with the SK 100 disconnected, even if a limit switch
on the left hand side of the mill housing switches the SK 100 off
when the door is opened.
* Press the button O at the main switch A or turn to
OFF position Fig. 5
* Put key C in screw B
* When the key is turned in clockwise direction, the hous-
ing is opened
* Close in reverse order
SK 100 comfort
Only open with the SK100 disconnected.
* Press the button O at the main switch or turn to OFF
position Fig. 6
* Push handwheel B1 and turn in anti-clockwise direction
* Handwheel latches into end position
* Close in reverse order
Only close the door if the contact surfaces are absolutely free of mate-
rial being crushed or other contaminants.
Mechanical components and the seal may be damaged.
!
Do not open the SK 100 with the motor running.
When crushing toxic or otherwise health-impairing materials, there is a
danger that health-hazardous particles may be inhaled.
!
Do not open the SK 100 and the motor brake simultaneously.
Danger of injury from unbraked cross beater.
Insert bottom sieve
Fig.7
Bottom sieves BS of stainless steel with Conidur or round holes
are available for selection as accessories. Fig. 7
Conidur
0.12/0.20/0.50/0.75/1.0/1.5/2.0mm
Round hole 3.0/4.0/5.0/6.0/8.0/10.0mm
* Stop SK 100
* Open mill housing
* Push in bottom sieve BS
* Close mill housing
Ensure that the collecting vessel has been mounted.
* Start the SK 100