RaySafe X2 Manual - Manual (Page 6)

NAVIGATE THE BASE UNIT
The base unit has a touch screen and three buttons.
Swipe up and down on the home screen to access your previously recorded measurements. Swipe right
from the home screen to go to the setup screen, from which you can make settings and view information
about the system, for example the calibration date for a connected sensor. Tap on a parameter to get
larger digits, one parameter at a time. You can also measure in this mode. From the single parameter
screen, you can swipe right to view the measurement specifications, and left to see waveforms, if available.
The three buttons below the screen are:
Menu , brings up a menu on the screen
Home , takes you to the home screen
Back , takes you back to the previous screen
On the back side of the base unit are:
Reset
switch, for forced reboot of the base unit
Charger/PC
connector, for charging or using with a PC with X2 View
mAs
connector, for tube current measurements
Two sensor connectors
Ethernet
connector, for future use
On/Off
switch. Press the button shortly to enter sleep mode. After a while in sleep mode, the base unit
will turn off automatically. Press the button for 2 seconds to turn off the base unit immediately.
RaySafe X2 User Manual
6