Setting: beam quality – RaySafe X2 Manual User Manual
Page 31
SETTING: BEAM QUALITY
The MAM sensor is ready to measure dose and HVL for all beam qualities without any settings. However, to
get a kVp reading you have to select a beam quality.
If your beam quality is not in the list, you have to change your anode/filter combination to one of the listed.
Expose, and you will get a kVp reading which is applicable to all anode/filter combinations for the
mammography machine (since the high voltage generator will behave identically regardless of selected
anode/filter combination).
Note!
This setting will only affect the kVp measurement.
RaySafe X2 User Manual
31