Dash – Precision Turbo and Engine BigStuff3 GEN3 Powertrain Controller Transmission Control Users Manual User Manual
Page 17
Bigstuff3 GEN3 Transmission Control Manual
The blue
background
designates that the
table is in “Edit
Mode”
When the key board
SHIFT key is
depressed, “Edit
Mode” is displayed
in the gear position
box.
Left & Right Arrow Keys - When the LP Table is in “Edit Mode” (the table background will be blue),
the left and right arrow keys can be used to scroll across the green lines in each window (gear).
Moving from window to window (gear-to-gear) within the LP Table can also be achieved using the left
and right arrow keys. Depressing the right arrow key repeatedly will move the cursor all the way to
the right in each window. When the cursor reaches the last line pressure point (to the right) in each
window, it will jump up to the next (gear) window. Using the left arrow key will move the cursor
(left) down from one window to the next until it reaches the first point in first gear LP window.
Up & Down Arrow Keys -The up and down arrows keys can be used to change the duty cycle % value
of any point, on any line, in the table. Use the left and right arrow keys to get to the desired line
pressure point in any window (gear). As the cursor moves across the line pressure points along the
green lines, the force motor duty cycle values for each line pressure point are displayed. Once the
desired line pressure point is reached, use the up and down arrow keys to increase or decrease the duyt
cycle % value for that line pressure point. The value (duty cycle %) can be increased or decreased in
1% increments.
To get out of “Edit Mode” hit the “SHIFT” key again.
The transmission is now ready for operation!
Dash
A Dash, (short for Dashboard) can be configured and displayed at the bottom of the TCC and Shift
Table “Operating Screens” within the BigComm software. A Dash needs to be selected, configured
and saved as a default before it will appear at the bottom of the BigComm software “Operating
Screen”. Up to thirty-one (31) individual Dashes’ can be configured to display various engine
parameters, also referred to as
.
17