Precision Turbo and Engine BigStuff3 GEN3 1st Gear Spark Retard with Traction Control System (SR2) - Manual (Page 15)

Rev 1.0 15
• With the system disabled, use the Replay function to collect data from a pass.
Once a “good” pass has been recorded using the “Replay” internal data logger, go to the “Torque
Management” drop down screen from the main BigComm tool bar and select “Driveshaft Replay” as shown
in the screen print below.
The following screen will open allowing you to choose the Replay you want to use to set up your “Desired
Driveshaft Curve”.
Double left click on the preferred Replay and the screen below will open. The screen on top is the Replay
selected, with only six (6) torque management related variables displayed. Below the Replay graph is the
“Desired Driveshaft Table” which will be used to develop the Desired Driveshaft Curve.