Paxton SONY number plate reader - Manual (Page 3)

Page 3
TCP/IP connections
Connecting to the PC
Connect your laptop PC via the supplied crossover cable to the camera. Power up the camera and the
Power (Green) and Status (Red) LED's will come on. After about 5 seconds the Status LED will go out.
Power up the PC and the Network connect LED (Green) should come on.
1. Run the web browser on the PC. This should be
Internet Explorer 5.0 or later with Windows XP or Vista.
2. Change your PC address into the: 192.168.0.x. range,
as the camera will not respond until the IP address of
the PC is brought into that range.
(See 'Changing the address on the PC' or contact Tech Support if required)
3. Connect to the following address: http://192.168.0.1
4. The cameras Network LED should now be active.
Once connected, the log-on screen should now display.
Enter the following - User name: net2
Password: net2
The main program window should then open.
Power LED
Status LED
LAN connection
Network connect LED Network data LED
The CPU Monitor, Reset, Mode
and USB connection are NOT
camera outputs. They are for
software upgrades only.