Paxton SONY number plate reader - Manual (Page 2)

Page 2
WARNING: There is no mains power
switch on the unit. Ensure that the mains
supply is turned off before working on
any part of the power supply of this unit.
115/230V AC power connection
Connect the AC mains
supply with Earth wire to
the terminal block
The supplied housing is a Videotec HOV. Detailed drawings are available on the back page.
HOV details: http://www.videotec.com/en/page_114.html
Brackets: http://www.videotec.com/en/page_267.html
INSTALLATION - Mounting brackets and hardware
Low voltage (12V DC) connection
If required, the camera system (without the condensation heater)
may be directly powered from a 1A / 12V DC feed.
Unplug the connection to the Heater. Remove the two screws
holding the connection board and the two screws holding the
power supply module. Lift these assemblies clear of the housing.
The Brown (0v) and White (12V) connections can then be
removed from the power supply terminal block.
Connect the 12V DC feed to these wires.
Ensure that the polarity is correct before powering up the unit. Incorrect wiring
may cause irreversible damage to the 12V / 5V regulator circuit.
Two mounting points are provided.
- Lateral - 2 x M5 bolts at 70 mm spacing
- Rectangular (with cable exit) - 4 x M5 bolts. 40 mm x 62 mm.
Connection to a Net2 ACU reader port
The data connection to the Net2 ACU only requires
the following signals.
DATA 0 Net2 - Yellow
DATA 1 Net2 - Blue
GND/0V Net2 - Black
Depress the white button on the connection block to
open the terminal and release it to grip the wire.
Connect the data cable to the Net2 ACU reader port.
WARNING: The lid section of the case is much heavier than the base. Take care when carrying
or mounting the unit with the lid open that the unit is fully supported or it could overbalance !!