Multiquip T12D50SA - Manual (Page 5)

LT12D50SA LIGHT TOWER • OPERATION MANUAL — REV. #0 (03/16/09) — PAGE 5
SAFETY INFORMATION
LIGHT TOWER SAFETY
DANGER
NEVER

use light tower in rain, snow, or
areas of high humidity that could generate
electrical storms.
NEVER  operate the equipment in an explosive
atmosphere or near combustible materials. An
explosion or fi re could result causing severe
bodily harm or even death.
WARNING
NEVER  disconnect any emergency or safety devices.
These devices are intended for operator safety.
Disconnection of these devices can cause severe injury,
bodily harm or even death. Disconnection of any of these
devices will void all warranties.
CAUTION
NEVER  lubricate components or attempt service on a
running machine.
ALWAYS  ensure light tower is on level ground before use
so that it cannot slide or shift around, endangering workers.
Always keep immediate area free of bystanders.
ALWAYS make sure trailer is leveled with all outriggers

extended before raising tower. Outriggers must remain
extended while tower is up.
ALWAYS keep area behind trailer clear of people while 
raising and lowering mast.
NEVER  remove safety pin or pull mast locking pin while
tower is in a raised position!
CHECK

the mast and winch cables for wear. If any
problem occurs when lowering or raising the tower,
STOP immediately! Contact a trained technician for
assistance.
NEVER  pivot or retract mast while unit is operating.
NEVER  use the light tower mast as a crane. DO NOT lift
anything with the mast.
NEVER

attach anything to the light tower mast.
ALWAYS

lower the light tower when not in use, or if high
winds or electrical storms are expected.
NOTICE
ALWAYS

keep the immediate area surrounding the light
tower clean, neat, and free of debris.
ALWAYS  keep the machine in proper running condition.
Fix damage to machine and replace any broken parts 
immediately.
ALWAYS

store equipment properly when it is not being
used. Equipment should be stored in a clean, dry location
out of the reach of children and unauthorized personnel.
To prevent the light tower from overturning,  NEVER use
in winds that exceed 65 mph (105 kph).
LAMP SAFETY
WARNING
NEVER  attempt to replace lamp with the power on.
Always shut down the engine and turn off circuit breakers
when changing the lamp.
ALWAYS

allow a suffi cient amount of time for the lamp to
cool before touching or changing. The possibility exists of
severe burns.
CAUTION
NEVER  use force when installing the lamp. Excessive force
could cause the lamp to break, causing bodily harm.
NOTICE
NEVER  leave any grease or oil residue on lamp surface
when replacing or removing lamp. This can create hot
spots, reducing the service life of the lamp.
ALWAYS

make sure lamp surface is clean and dry.
ALWAYS  replace with MQ recommended type lamp.
ALWAYS  have a trained technician install and remove
a fl oodlight, or replace any damaged fi xture wiring.