Multiquip T12D50SA - Manual (Page 17)

LT12D50SA LIGHT TOWER • OPERATION MANUAL — REV. #0 (03/16/09) — PAGE 17
COMPONENTS
Safety Chain 14. — Always attach safety chain to the
towing vehicle. Never tow the light tower with the safety
chain unattached.
Ball Hitch Coupler 15. — Attach this coupler to the
towing vehicle. Use only the specifi ed ball diameter
as indicated on your coupler. Use of any other ball
diameter will create an extremely dangerous condition
which can result in separation of the coupler and ball
or ball failure.
Vertical Mast Winch 16. — Use this winch to raise the
mast to the vertical position.
Mast Lock/Release Pin 17. — Pull this pin to start placing
the tower mast in the vertical position.When tower mast
has reached full vertical position, insert pin to keep
mast from falling.
Tie-Down Points 18. — Used to tie down light tower with
strap or chains to allow even application of force to the
front and rear of the equipment during transport.
License Light 19. — This light illuminates the license plate.
Whenever towing of the light tower is required, make
sure this light is operational.
Brake Lights 20. — Before towing the light tower, make
sure that these lights are operational and are working
correctly. Never tow the light tower if these lights are
inoperative.
Engine Exhaust Pipe 21. — Directs engine exhaust to
the rear of the light tower. NEVER block this exhaust
pipe with obstructions. ALWAYS place the generator
in an area free of obstructions.
Tires 22. — This light tower uses a ST175-13C size tire.
Replace with only recommended tire size. Never tow
light tower with bad or worn tires.
Documentation Box 23. — Contains information
regarding the light tower.
Auxiliary Output Receptacle Plate 24. — Wired ready
to install an output receptacle.
Auxiliary Output Receptacle Plate 25. — Wired ready
to install an output receptacle.
Major Components (Front/Rear) Figure 4.
REAR
VIEW
22
19
23
25
24
FRONT
VIEW
20
21