Multiquip SP2S20H - Manual (Page 39)

Sp2S20h paVeMeNT SaW • operaTioN MaNual — reV. #1 (02/17/12) — page 39
Maintenance
Figure 48. Hydrostatic Transmission
Spline gear Wheels
Check every 25 hours and clean as necessary. If the spline
wheels Do NoT engage the rear wheels with sufficient
pressure, slippage of the rear wheels may occur.
To adjust the Spline Gear Assembly:
1. Place the transmission engage/disengage lever in the
DiSeNgage position (Figure 49).
Figure 49. Transmission Lever
(Disengaged Position)
NOTICE
Excessive tension on the drive chain will reduce chain
life.
LOOSEN
SCREWS
4 PLACES
HYDROSTATIC
TRANSMISSION
U-SLOTS TRANSMISSION
MOUNT
2. Loosen the linkage adjustment nut and slightly lengthen
the linkage rod (Figure 50).
Figure 50. Linkage Adjustment
3. Move the transmission engage/disengage lever to the
eNgage position to observe the proper spline-to-rear
wheel contact (Figure 51).
Figure 51. Transmission Lever
(Engaged Position)
4. Retighten the adjustment nut.
LINKAGE
ROD
ADJUSTMENT
JAM NUT
TRANSMISSION
ENGAGE/DISENGAGE
LEVER
CONTACT
POINT
REAR WHEEL
SPLINE
GEAR