Multiquip SP2S20H - Manual (Page 30)

page 30 — Sp2S20h paVeMeNT SaW • operaTioN MaNual — reV. #1 (02/17/12)
8. Rotate the ignition switch to the STarT position to
engage the starter.
Figure 25. Ignition Switch (START) position
9. Once the engine has started, slowly return the choke
lever (Figure 22) to the CloSeD position. If the engine
has not started repeat steps 4 through 8.
10. Before the saw is placed into operation, place the
throttle lever in the FaST position and run the engine
for several minutes. Check for fuel leaks and noises
associated with a loose guard and/or covers.
Figure 26. Throttle Lever (FAST Position)
NOTICE
All cutting is done at full throttle. The engine governor
has been set at the factory to ensure an optimum
speed setting.
startup
CauTioN
alWayS cut with the saw at Full ThroTTle.
Attempting to cut with the saw at less than full throttle
could cause the blade to bind or stop abruptly in the
slab resulting in serious injury to the operator or others
in the area.
CauTioN
Do NoT try to cut faster than the blade will allow.
Cutting too fast will cause the blade to rise up out of
the cut. Improper cutting rate can decrease the life of
the engine and blades.