Multiquip J36E2 - Manual (Page 21)

J36e2 elecTric WalK-BeHiND TrOWel • OperaTiON aND parTs maNUal — rev. #0 (07/24/12) — page 21
OperatiOn
To move the trowel to the operator’s
left, on the handle, to move the
trowel to the right on the
handle.
lift up
push down
Remember!
STOP
that if you let go
of the trowel, just
and let the trowel come to a
complete before trying
to recover the trowel.
step away
The best method for finishing concrete is to
slowly walk with the trowel, guiding
the trowel from side to side. This will cover all
footprints on wet concrete.
backwards
BACKWARDS
BACKWARDS
Figure 12. maneuvering the Trowel
caUTiON
NEVER place your feet or hands inside the guard rings
while starting or operating this equipment.
caUTiON
alWays keep clear of rotating or moving parts while
operating this equipment.
maneuvering the Trowel
1. Get into the operator’s position behind the handle. With
a secure foothold and a firm grasp on the handle, slowly
increase the engine speed until the desired blade speed
is obtained.
2. Figure 12 below illustrates a typical walk-behind trowel
application. Practice maneuvering the trowel. The trick
is to let the trowel do the work.
3. Continue to practice maneuvering the trowel. Try to
practice as if you were finishing a slab of concrete.
Practice edging and covering a large area.
Remember a good finishing technique is to work
backwards. Be careful when moving backwards so
that hazards can be avoided. The best way to get
accustomed to the trowel is repeated use.