Multiquip MTR40F - Manual (Page 19)

MTR40F RAMMER — OPERATION AND PARTS MANUAL — REV. #3 (01/05/12) — PAGE 19
Fuel Lines
■ Check the fuel and oil lines regularly for damage and ensure
that there are no leaks.
■ Replace the fuel lines every two years to maintain the
performance and flexibility of the fuel lines.
Cleaning the Rammer
■ If using a high pressure spray washer, be careful not to splash
water directly on the air cleaner, carburetor, muffler, and fuel
cap. Excessive amounts of water may cause severe engine
damage.
Long Term Storage
■ Drain fuel from fuel tank, fuel line and carburetor.
■ Remove spark plug and pour a few drops of motor oil into
cylinder. Crank engine 3 to 4 times so that oil reaches all
internal parts.
■ Clean exterior of rammer with an oil-moistened cloth.
■ Store unit covered with plastic sheet in moisture free and
dust free location out of direct sunlight.
Crankcase Lubrication
■ The rammer
crankcase bearings (Figure 19) should be
lubricated with five shots of grease with a hand grease gun
after each eight (8) hours of use.
■ Use MQ HIGH TEMPERATURE GREASE, P/N GRS2 or its
equivalent.
Spark Plug
■ Remove and clean the spark plug (Figure 20), then adjust
the spark gap to 0.024 ~0.028 inch (0.6~0.7 mm). This unit
has electronic ignition, which requires no adjustments.
Figure 20. Spark Plug Gap
Figure 19. Grease Fittings (Crankcase)
MAINTENANCE
Refer to manufacturer engine manual for specific
servicing instructions.
NOTICE